PCB Wizard to Mache3

[Fred]

If the drill file is small, you may just have a confusion over units. I know in my case Eagle defaults to inches and my CNC setup defaults to millimetres.

[Moonshadow]

If the drill file is small, you may just have a confusion over units. I know in my case Eagle defaults to inches and my CNC setup defaults to millimetres.

Good thinking Sir, I will investigate. THank you for your reply. John.

[HankMcSpank]

I milled a lot of pcbs with my CNC machine.

I used to designed the circuit/board in Eagle, save it to Gerber, then I used Cambam to import the Gerber & then have Cambam produce the g-code.

[Moonshadow]

i have purchased CopperCam and that seems to have solved my Gerber to Nc. Conversion problem. Great program and worth every penny. Now all I have to do is make it work with Mach3.

[HankMcSpank]

Good that you're sorted :-)

It's been a couple of years since I've done much PCB milling, but this new (free) kid on the block looks to have real potential too FLATCAM...

https://www.youtube.com/watch?v=IbsBCMlQB_c