Z drive not working on cnc plasma

[whensparksfly]

Swaping the driver's or swapind the motor wires from z to x makes no difference I will post a picture on input tomorrow thank you for you help

Sent from my SM-G361F using Tapatalk

[JAZZCNC]

Swaping the driver's or swapind the motor wires from z to x makes no difference I will post a picture on input tomorrow thank you for you help

So your saying if you swap Z axis motor wires to the Working X axis drive it still doesn't work.? If so then dead motor.
(Daft question here.? . . . Obviously swapping Z motor to X axis will only work if you jog X axis your not swapping then trying to jog Z are you.?)

Have you tried swaping Z axis drive to the X axis motor.? This will eliminate dead Z axis drive. IF Z drive works X motor then sounds like your Z axis motor is dead.