Advice on converting my VMC

[Proteus]

Hello Boyan, and thanx for reply :-)
Yes, i have been looking at these controllers.
Found several of them at ebay like this one http://www.ebay.com/itm/English-Pane...oAAOSwG-1Wy-32
Dont mind being a guinea pig, but my experience in programming CNC is not exactly fierce. Which means i would like to start with making the drawings and run it from there(that i do have some experience with).
In time i want to start playing around with the programming part in depth.
Right now i follow my old KISS(Keep It Simple Stupid) theory, trying to find a cost effective solution i can start with.
However, manuals have been downloaded some time ago and i will attempt to study this in due time.

[Chaz]

Hello Boyan, and thanx for reply :-)
Yes, i have been looking at these controllers.
Found several of them at ebay like this one http://www.ebay.com/itm/English-Pane...oAAOSwG-1Wy-32
Dont mind being a guinea pig, but my experience in programming CNC is not exactly fierce. Which means i would like to start with making the drawings and run it from there(that i do have some experience with).
In time i want to start playing around with the programming part in depth.
Right now i follow my old KISS(Keep It Simple Stupid) theory, trying to find a cost effective solution i can start with.
However, manuals have been downloaded some time ago and i will attempt to study this in due time.

3 Axis even a bit cheaper.

http://www.ebay.com/itm/English-Pane...3D331785938231

[Proteus]

Chaz,
I apologize if my question can seem somewhat stupid, but how do i control the 4/5th axis cradle if i install a 3 axis controller ?
Jupp.. I`m a newbie :-)