. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #12
    -Windows is crappy, PC even a cheap one could become quite expensive when starts to waste your time. Especially if you value it. You need right away to change the disk to a flash drive to avoid reliability problems, reinstall windows and so on,
    I know that for a fact, even that i am a Pc geek. What about the people that are not?
    Boyan How can you say the above with conviction. Windows is not crappy and you certainly do not require to change the hard drive to a flash drive. Hard drives will run for many years without any problems. Flash drives are new on the block and have not been tested for many years in service as yet. Although I am getting to like them.
    at the other hand:
    etc. We could say the same about the Russians but that would not be fair either

    -if you hire sb from west expect >50-60 per hour for that job. I know at least of a couple of companies that could sell you the controller a bit more expensive but know what they are doing and speak English. So presale questions could be asked and even they could do the heavy lifting with the ATC setup.
    If you know where to buy these and get good support why not put links up. Remember this is a forum to help each other not for self gain.
    Last edited by Clive S; 27-09-2016 at 09:28 AM.
    ..Clive
    The more you know, The better you know, How little you know

  2. The Following User Says Thank You to Clive S For This Useful Post:


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Looking into converting my Mill to CNC
    By T0rnado69 in forum Emco Milling Machines
    Replies: 16
    Last Post: 14-02-2019, 12:46 AM
  2. Advice Needed, Converting a Boxford VMC 190
    By Marv2097 in forum Boxford Vertical Mills
    Replies: 17
    Last Post: 19-12-2016, 05:53 PM
  3. converting pdf to cam?
    By motoxy in forum Computer Software
    Replies: 7
    Last Post: 28-02-2014, 08:11 AM
  4. Converting sketchup to dxf
    By motoxy in forum Sketchup
    Replies: 3
    Last Post: 08-07-2012, 12:04 PM
  5. Converting Cardboard to DXF
    By Yow Ling in forum General Discussion
    Replies: 12
    Last Post: 15-11-2010, 10:18 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •