mach3 help

[D-man]

LOL.

Steve. the wires that ive used are just standard electrical wires. i had an old electric heater i stripped and used the power cables. ONLY to test tho they will not stay there. i have some signal wire from gary for those.

The ground cable goes from each GND on the uniport to

PULL-(PULL)
DIR - (DIR)
ENA- (ENA)
On all drivers

ENA+ is disabled on all driver as im running the 5v from the USB

So are you saying you want me to disconnect the GND from the uniport and link them all together on the drivers?

[HiltonSteve]

LOL.


So are you saying you want me to disconnect the GND from the uniport and link them all together on the drivers?

NO!

Just re-read this post and thought I better clarify, the GND needs to common on the Uniport and the drivers. Use GND connections on the uniport and connect them to the driver GND's only, not the PUL- or (edit) DIR-.
.