10mm belt nema23

[paulus.v]

The motors you are using are relatively high Inductance so will require more voltage to spin fast

Hi Dean,

It would not be advisable to get the am882 drives and a decent toroidal psu (I guess around 60v, you have more experience..)?

I see that he had invested a lot in his build but got stuck with some crap drives, and he only needs two of them.

edit:

the only settings that can be set in controller is calibrate the distance moved, table size, homing switches

Kev, I told you about the importance of setting up acceleration. Did you get the idea?

From your controller manual:

【Max Acc.】: Acceleration when axis making accelerated or decelerated movement. Too a big setting may lead
to motor losing steps or dither; too small setting may cause slow acceleration and then slow
processing speed for whole image. For axis with big resistance, such as Y axes corresponding
with beams, typical setting should be within in 800～3000mm/s2 ; For axis with small resistance,
such as X axes corresponding with carts, typical setting should be within in 10000～
20000mm/s2;