Looking for Help cutting composite material

[webdude12]

Actually I am in the US, but this board has been much more helpful then any of those I have found over here.

I can still ship something to you. Would a 60 cm square piece work? or would you like something bigger? I really wouldnt need the sample returned, just if you could take a picture of the edge and post it, that would be great.

[HiltonSteve]

60cm square will be plenty. Do you have any example profiles that I could cut with typical corners etc? If so then send me the drawings.

I will pm you my address.

Do you have any preference on the cutters that you want me to try cutting it with? Like I said before I have some 3mm carbides with 3 flutes but I am finding that you have to run these at very fast feedrates to get anything like the correct chip load. I am sure 1 or 2 flutes would be much better.

[irving2008]

Actually I am in the US, but this board has been much more helpful then any of those I have found over here.

The old british 'can do' attitude :clap:

Whereabouts in US? IP address suggests Atlanta, or at least southern states...

Intrigued about these 'kits'... kits for what?