Thor, or should that be Zeus?

[Chaz]

8mm ordered anyways to check. I'm not sure how free flowing the water should be through the spindle, I went as far as removing the pipes and I get a slow flow, so I dont think its that.

[Clive S]

8mm ordered anyways to check. I'm not sure how free flowing the water should be through the spindle, I went as far as removing the pipes and I get a slow flow, so I dont think its that.

I have known the spindle fittings to be blocked when they seal the top bit on. Take off the tubing and poke a small screw driver down the hole to see if it is restricted about 25mm down. I only use a 2 ltr tank and a very small fish tank pump around £3

[Chaz]

I have known the spindle fittings to be blocked when they seal the top bit on. Take off the tubing and poke a small screw driver down the hole to see if it is restricted about 25mm down. I only use a 2 ltr tank and a very small fish tank pump around £3

Thanks. I did think of that - I tried to blow into it but a bit limited in terms of space. The black grommit things were removed, wasnt sure if there could be anything else blocking.

[Clive S]

Thanks. I did think of that - I tried to blow into it but a bit limited in terms of space. The black grommit things were removed, wasnt sure if there could be anything else blocking.

If you put a temp. tank above the spindle with one pipe to the spindle and the other pipe lower down into a bucket and siphon the water it should run freely. I take it is one of the normal Chinese spindles

[Chaz]

If you put a temp. tank above the spindle with one pipe to the spindle and the other pipe lower down into a bucket and siphon the water it should run freely. I take it is one of the normal Chinese spindles

Yep, 4KW unit.

[Clive S]

Yep, 4KW unit.

Chaz I have not seen one of those so can't comment but the water should still flow through and I would expect you to have a bigger tank

[Chaz]

Chaz I have not seen one of those so can't comment but the water should still flow through and I would expect you to have a bigger tank

At the moment im just using a plastic bucket filled with water (probably 5-6 litres) at ground level. I raised it manually by hand to lower the head distance however it made no real difference. I suspect something must be blocked but the limited flow wasnt exactly inspiring either, so I need to improve that. Without the the thin tubing, the pump pushes out a fair amount of water.