Help with spindle please

[magicniner]

Not got Google

https://www.isel.com/en/downloads/dl...h_englisch.pdf

?

[Steve-m]

Not got Google

https://www.isel.com/en/downloads/dl...h_englisch.pdf

?

yes got google but that tells me nothing, if you cant say any thing helpfull why say any thing?

I asked what collets and what nut, not for smart mouthed comments

[magicniner]

They are proprietary, not an industry-wide standard like ER collets, that is where to buy them from, along with part numbers.

[Steve-m]

thanks Got a price for a 3.175mm - 1/8" collet from them today £45 + £5 postage for each size, think a chineese ER11 spindle is the way to go. was hoping that someone may know if there Kress there a lot cheaper, google dose not know before some smart arse chimes in with google is your friend

Steve

[magicniner]

..

[Steve-m]

Thanks

[Steve-m]

This listing states the range of spindles which the listed collet will fit -

http://www.ebay.com/itm/Spring-colle...-/331902104103

I found this listing in 5 minutes using a little intelligent searching using........




Yes, you guessed it, Google!

I was tempted not to bother but it might help someone else later.
***************

Thanks its helpfull to know there the same, but my spindle is a UFM 500 not listed

[magicniner]

It actually looks like they aren't, the part numbers for the 500 and 1050 collets are different and Kress listing suggests they share a fitting with the 1050, not the 500.