TTS Tooling system

[battwell]

no- it has to be nc (but could use a 2803 inline to invert signal)
why would you want to? nc allows probe to be checked ready - ie not stuck and connected before probing and after backoff

[Davek0974]

no- it has to be nc (but could use a 2803 inline to invert signal)
why would you want to? nc allows probe to be checked ready - ie not stuck and connected before probing and after backoff

I use a touch plate on the high-speed setup - this is naturally N/o circuit, if its shorted or N/c then probing does not trigger, i was looking for an easy install :)

[battwell]

just a matter of changing probe signal active high to active low in software. are you using mach3? or?


uccnc has added a second probe input so 1 can be configured nc and one no - genius.lol
i have 2 spare probes arriving today from germany ( and 2 for my machines)

[Davek0974]

Using Mach3 and CSMIO-IP/A controller.

Will have a look