Search:

IMO The advantages of "taper-lok" and my DIY ER solution is that they are more compact, better concentricity, better grip, no damage to the shaft from grub screws, infinite ajustability and...

Taperlocks are used extensively in industry, I have made my own using ER collets, pic of one on my bench mill and one on my router, both driven by servos

Have sent PM

Big fan of Nilfisk myself, concocted this from bits bought from fleabay, the cyclone is mounted in the middle section. The nilfisk motors are continuously rated, not too noisy and will run 10hrs non...

I have been using an Arduino to control a router for a few years using Estlcam, takes Gcode

I have a basato 3 bandsaw and often cut aluminum from 2 - 50 mm thk without any problems. I use an M42 blade 1/2" x 4tpi, it has been in the m/c for a few years, I am not a fan of fine pitch blades...

Link to your video is not appearing.

Just tried a win10 PC at it appears OK

[QUOTE=EddyCurrent;109021]Looks okay, did you check both ends with radius gauges ? [QUOTE]

Man with guages says "perfect" :adoration:

I would have thought that the green idler removes the backlash with the red idler providing belt tension. I designed a somewhat similar layout for a servobelt drive I built.

I have been running a MK2 planet board for a couple of years and works very well for me , but all their effort is now going into their MK3 board which does have Ethernet and USB. Support is good and...

Since there is no requirement for a venturi or pressurized container almost anything works, I just used an old NOGA that I had.

I made it for myself, I have no commercial intentions whatsoever. I...

Pickup from where

Is the fan motor 1 ph or 3 ph

Sorry but modifying some one else's motor would be a bit scary :eek:, I persevered with mine mostly because I was told it's not possible and I could see no reason that it could not be done, just a...

Hose Fittings 4 - 4mm Barbed Hose Elbow Connector Blue Nylon | eBay
Tefen Elbow Hose Joiner (Nylon/Plastic) | eBay
90° Right Angle Elbow Connector- Barbed Nylon PA66 Joiner for Tube Pipe or Hose |...

used 4mm nylon elbows which were a push fit into the carriage

When Robot Programmers get bored - YouTube