Step-Four problems

**Pylonracer** · 17-10-2018

Originally Posted by toninox

Plyonracer, could you please share mach3 parameters? i really can't configure it

if someone need i can share the milling sofware v4
rev. 6 of sept 0406
that is great for 2 and 2,5d milling/engrave jobs but doesn't support 3d modules
it works in win98 system

Hello Toninox

I will get the settings recorded and will post them for you.

Regards

Barrie

**rpbenito** · 18-03-2020

Originally Posted by Pylonracer

Hello Toninox

I will get the settings recorded and will post them for you.

Regards

Barrie

Hi Pylonracer!

Is there any chance that you could share the settings with me, please? I will really appreciate that! I've got a old Basic 540 and it's driving me nuts! :D I can get it work but I'm not sure all the settings are right.

Thanks!

Regards.
Raul

**toninox** · 18-03-2020

Originally Posted by rpbenito

Hi Pylonracer!

Is there any chance that you could share the settings with me, please? I will really appreciate that! I've got a old Basic 540 and it's driving me nuts! :D I can get it work but I'm not sure all the settings are right.

Thanks!

Regards.
Raul

at the end Pylonracer never post anything
if you need the old original software in win98 / msdos and relative parameters. write me lucio @ reciclandino . com