Putting together a stepper motor kit

[Clive S]

Hi all, I have been researching a 3 axis stepper motor kit, from the advice I have been given this forum, I have decided to go with a 80v set up, have seen some stepper motors from cnc4you, they are 8 wire 4Nm model number 60BYG401-03, and also the drivers to match which are 6.0A, 80V CNC Microstepping CW8060, also from cnc4you, i need advice on the the psu and the breakout board to with the motors and drivers, I am not quite sure which would best, either from cnc4you or elsewhere. Any advice would be very much appreciated. Thanks Paul

For the machine I think you have I would just use a simple bob to get you going if the PC has a PP https://www.ebay.co.uk/itm/5-Axis-CN...gAAOSwHUlbkLzl

[Paul53]

For the machine I think you have I would just use a simple bob to get you going if the PC has a PP https://www.ebay.co.uk/itm/5-Axis-CN...gAAOSwHUlbkLzl

Hi Clive, regarding the machine, I have basically stripped it down, I am rebuilding the whole thing, replacing wooden frame with 10mm aluminium plate, everything is being made out of this, the spindle mount, side supports etc, the only thing I am using is the spindle (water cooled) and the inverter, so basically starting again, haven't decided whether to mount all the drivers etc in a pc case or get/make a purpose built control box