NordicCNC's build log

[JAZZCNC]

The drawback will be that it becomes more difficult so access the machine table from the side, when e.g. fastening the workpiece.

Yep there's always going to be some trade off with design like this, you just have to decide which is most important to you.!

[NordicCnc]

Yep there's always going to be some trade off with design like this, you just have to decide which is most important to you.!

Yes.

If I think about it, side loading would not be too complicated with only 200mm raised gantry sides. You can still reach for all the clamps quite well and large wooden sheets can be loaded from the front.

The purpose of the high gantry sides was exactly for that reason, to simplify side loading. But now when analysing the problem closer, this will probably not have any impact to me at least.

Time to modify the design... again!

Skickat från min SM-A530F via Tapatalk