Hello from Grenoble

[lewiss66]

For whoever is reading this thread I'm talking also about my second problem which is my motor that is acting up.

Actually I removed the two top screws and the cover came off at the top only but got stuck at the bottom, then removed the two bottom screws at the back of the cover but still doesn't want to come off. It could have been simpler if my mill was on the bench but unfortunatly it's still in the crate. Yes I was not expecting to buy it that soon and haven't build the table. But I wasn't not expecting to have those two problemes right at the checking when I got the mill.
So It could just be the cover that rub against the bottom plywood of the crate but I have not much room to access and if someone knew what screws to unbold that would help me to get into it directly without contortions :)
Anyway I just received from Arceurotrade the motor control board so I might have to push the heavy crate anyhow to install it ...

[Doddy]

Anyway I just received from Arceurotrade the motor control board so I might have to push the heavy crate anyhow to install it ...

Motor Control Board? More problems? You show the spindle binding with the spindle belt removed - so I thought this was just a mechanical issue with the spindle?