Cnc Code Maker - 2D CAD/CAM

**CncCodeMaker** · 04-03-2010

Windoze unfortunatly, but if people nag hard enough I could probably give a shot at trying tpo port it. It is after all written in Delphi, and should be possible to compile it in Kylix (never tried it

)

**Swarfing** · 04-03-2010

Just to let you now it all installed fine on XP SP3 on Virtualbox and all worked straight out the box. Took a couple of minutes to realise th need to use the CTRL key for drawing but first impression looks very good. Well done:clap:

**CncCodeMaker** · 04-03-2010

Thank you for the feedback, that's good to hear. :)

Yes, I really need to write a short "quick-start" guide... I'v got a small video recorded (Xvid) here, that just shows the general flow:
http://www.cncsimple.com/videos/demo1.avi

Right-clicking will bring up the value input box (if a value needs to be entered), holding control will let ju sketch points.

**pete910** · 16-04-2010

Originally Posted by CncCodeMaker

Windoze unfortunatly, but if people nag hard enough I could probably give a shot at trying tpo port it. It is after all written in Delphi, and should be possible to compile it in Kylix (never tried it

)

Works spot on in wine 1.36 to 1.41 on Mandriva no probs!

But a native version would be nice!

Pete