Rotary axis, z lift before rotate query

[marbles]

Thanks for the comments guys. My knowledge of G code instructions is very limited as you can tell. I've added the line Jazz suggested to the startup code. l'll try out the new setup tomorrow :)

[JAZZCNC]

Thanks for the comments guys. My knowledge of G code instructions is very limited as you can tell. I've added the line Jazz suggested to the startup code. l'll try out the new setup tomorrow :)

When you run this code turn down the feed rate percentage just in case it doesn't work as expected.!! . . . . Or put another don't blame me if it crashes if you don't. . .Lol

[marbles]

Will do :)