Boxford TCL 125

**depronman** · 25-09-2020

As the 160 been converted to use from a pc or does it need the boxford software ?
This is important if you want a working lathe out of the box as boxford software is both expensive and they may well not even sell it to you

Paul

Sent from my iPhone using Tapatalk

**JAZZCNC** · 25-09-2020

Like Depronman says ATC isn't all that.!! .. . .esp the Boxford ATC which IMO are sloppy dinky toys with weak motors, the slightest friction or unbalance and they bind.

If you are not planning on leaving it unattended then a good QCTP will be stronger and more accurate.

**John11668** · 25-09-2020

Originally Posted by JAZZCNC

Like Depronman says ATC isn't all that.!! .. . .esp the Boxford ATC which IMO are sloppy dinky toys with weak motors, the slightest friction or unbalance and they bind.

If you are not planning on leaving it unattended then a good QCTP will be stronger and more accurate.

All noted ! Will think about it over the weekend but you guys are swaying me away from160

**John11668** · 25-09-2020

Originally Posted by depronman

As the 160 been converted to use from a pc or does it need the boxford software ?
This is important if you want a working lathe out of the box as boxford software is both expensive and they may well not even sell it to you

Paul

Sent from my iPhone using Tapatalk

I cant imagine there would be any software included so I expect to have to suss out how to connect whatever software i choose to go with.