X2 Mill motor Problem

[Ianwallis]

Yes, didn't spot that until after I pressed the Post button. One of the problems with Googling for a topic! Have got some advice from elsewhere so starting the checks.

[dazp1976]

Yes, didn't spot that until after I pressed the Post button. One of the problems with Googling for a topic! Have got some advice from elsewhere so starting the checks.

Waste of time the X2 if it has the 350w motor. My pot has gone screwy on one of them. Both my X2's are just sat there. Occasionally use the manual one for drilling holes. (they work but my Amat25 is sooooo much better).

You're prob better off buying one of these when it comes in:

https://www.amadeal.co.uk/acatalog/A...E.html#SID=420
Better travels, brushless, R8 (far superior).


Like, The X2 motor is £130, then it could be the board which is another £140, all adds up.
Must admit though, I did upgrade my manual one to metal gears. Thing will take your hand off now lol!.