Hardinge Lathe CNC Retrofit/Conversion

[m_c]

Ive got 2 of them. I can try but I'm not sure if that would power the spindle System without causing issues. Keep in mind that the power from the Ecogoo 9000 and 9100 is higher voltage (chopped) to make 380V.

I'm currently running my complete lathe via a 7.5kw boost inverter, albeit still with the motor from my old rotary phase converter running to provide some base load, and a sine wave filter to ensure no transients make it to the lathe.

[Chaz]

I'm currently running my complete lathe via a 7.5kw boost inverter, albeit still with the motor from my old rotary phase converter running to provide some base load, and a sine wave filter to ensure no transients make it to the lathe.

So something like the Ecogoo 7.5KW directly into a lathe? What lathe?

[m_c]

So something like the Ecogoo 7.5KW directly into a lathe? What lathe?

This lathe - http://www.mycncuk.com/threads/13970-New-CNC-lathe-day

My current set up is-
7.5KW Boost VF -> sine wave filter -> idler motor (the setup may work fine without it, but it does provide a bit surge/buffer capacity) -> 3ph distribution.
For sine wave filters - https://www.controlpanelproducts.co....o-1200A-CNW933

Due to the workshop being fed via a quite sensitive RCD, I do also have a 7.5KVA isolating transformer feeding the VFD, but you shouldn't need that.

With that setup, the lathe runs fine, although it does dim the lights if I reverse the spindle...