. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 02-05-2021 #14
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Quote Originally Posted by JeffZ View Post
    Are you referring to the LC60H2102, LC60H2112, LC60H2127 series motors?
    They were my preferred choice initially, and I only removed them from my list of options because shipping was close to 200€ for 4 motors (from the Lichuan aliexpress store).
    Are you driving them using the Lichuan LCDA86H drivers?
    My original plan was to run 4xLC60H2127 + LCDA86H at 60VAC.
    Yes, the LC60H2102 and LC60H2127 with LCDA86H drives for the Nema 24. For the NEMA 34's I use the 10Nm LC86H3156ZB 3 phase motor with LCDA2260E 220V drive.

    I buy them in bulk (100sets) and have them custom built with 5mtr cables and also have the annoying 15pin Dsub connectors removed. I ship them via Sea so the cost is lower but yes shipping via Air freight is expensive these days.
    For UK builders I offer to supply them, along with UCCNC controllers, WC-spindles, etc but given Brexit and the EU situation I don't really want to get into sending outside of uk due to export hassles.
    -use common sense, if you lack it, there is no software to help that.

    Email: [email protected]

    Web site: www.jazzcnc.co.uk
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to JAZZCNC For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 12 users browsing this thread. (0 members and 12 guests)

Similar Threads

  1. Carbide taper ball nose cutters
    By Leadhead in forum Tool & Tooling Technology
    Replies: 2
    Last Post: 08-01-2020, 06:45 AM
  2. Is there a Lee on eBay from china who is good for ball screws and guides from please?
    By suesi34e in forum Rails, Guideways & Bearings
    Replies: 1
    Last Post: 13-11-2015, 12:40 AM
  3. have you put ball screws on an X2plus?
    By bmbaz in forum Milling Machines, Builds & Conversions
    Replies: 5
    Last Post: 14-05-2014, 06:56 PM
  4. buying ball screws
    By bmbaz in forum Marketplace Discussion
    Replies: 2
    Last Post: 10-05-2014, 03:57 PM
  5. Best way to machine ball screws?
    By Ross77 in forum Lead Screws, Nuts & Supports
    Replies: 34
    Last Post: 17-06-2012, 05:10 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules