Threaded View
-
11-07-2021 #24
Last Activity: 19-01-2024
Ok well you might be screwed then regards proper slaving, you could always just connect both drives to one motor output, it's not the correct way but will get you working. The downside is you can't home each side independent to square the gantry without getting creative.
Originally Posted by regpye
I have tried that Jazz, the plugin seems to be fixed and not editable. Nothing happens when clicking the yellow button.
-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Please help - missing steps ... Mach3
By emilvv in forum Artsoft Mach (3 & 4)Replies: 21Last Post: 23-12-2019, 08:31 AM -
New Mach3 settings but limit switches do not work, using a JK02 breakout board help!
By JimK in forum Artsoft Mach (3 & 4)Replies: 1Last Post: 27-09-2019, 11:54 PM -
switches settings in mach3
By Palletlad in forum General DiscussionReplies: 2Last Post: 17-09-2019, 05:40 PM -
Mach3 turn screen missing items / incomplete?
By mondrota in forum Artsoft Mach (3 & 4)Replies: 7Last Post: 27-02-2018, 06:30 PM -
Help withController dip switch settings and Mach3 motor tuning
By liamo1991 in forum Motor Drivers & ControllersReplies: 2Last Post: 15-11-2013, 02:22 AM
Bookmarks