step and dir pulse problem Mach3

[mrmacca]

Cheers Jazz,
Found plugin and installed and all is working , only slight problem is that when it goes back to home its out by a couple of mm, did a cut on a small file that uses 4 passes and it looked fine , no missed steps as far as i can see not like before when it went out by miles. Anyway going to see how it goes before i decide if i am going to change anything so
thanks for all the advice.
Dave

[mrmacca]

Cheers Jazz,
Found plugin and installed and all is working , only slight problem is that when it goes back to home its out by a couple of mm, did a cut on a small file that uses 4 passes and it looked fine , no missed steps as far as i can see not like before when it went out by miles. Anyway going to see how it goes before i decide if i am going to change anything so
thanks for all the advice.
Dave

Hi Jazz ,
Been a few months and still having problems, so will purchase controller you mentioned the AXBB-E controller ......Is that all that I need to purchase.
Cheers
Dave

[JAZZCNC]

Hi Jazz ,
Been a few months and still having problems, so will purchase controller you mentioned the AXBB-E controller ......Is that all that I need to purchase.
Cheers
Dave

To use the AXBB-E you will need 5Vdc and 24Vdc in the control box so you might need a PSU depending on what you have already. You can use 12Vdc in place of 24Vdc if don't have it, Some people use an old PC power supply that has both 5V and 12Vdc outputs.

Other than that all you need is an Ethernet cross-over Cable if running directly to PC or a standard Ethernet cable if running through a network hub or Switch.

[mrmacca]

To use the AXBB-E you will need 5Vdc and 24Vdc in the control box so you might need a PSU depending on what you have already. You can use 12Vdc in place of 24Vdc if don't have it, Some people use an old PC power supply that has both 5V and 12Vdc outputs.

Other than that all you need is an Ethernet cross-over Cable if running directly to PC or a standard Ethernet cable if running through a network hub or Switch.

Cheers for the quick reply, will let you know how i get on.

[Clive S]

Cheers for the quick reply, will let you know how i get on.

I take it you have looked at Dean's website Web site: www.jazzcnc.co.uk