Thread: Run a stepper from 2 DM542 drive
Hybrid View
-
26-12-2021 #1
Last Activity: 4 Hours Ago
That looks fine for the switch/relay side wiring.
Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
26-12-2021 #2
Last Activity: 08-01-2022
On the relay side I will have Pul-, Pul+, Dir- and Dir+ from the stepper drive on the NO and Pul-, Pul+, Dir- and Dir on the NC for the measuring device. The only thing which is not very clear is if I need to supply 24V from the stepper drive to the measuring device or that needs to be wired separately from the power supply (the same one which supply the stepper driver). Please have a look and comment.
Originally Posted by m_c
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How to wire the enable pin on a stepper drive?
By cncJim in forum General ElectronicsReplies: 8Last Post: 01-01-2016, 05:10 PM -
WANTED: parker CD20 stepper drive
By drumsticksplinter in forum Items WantedReplies: 0Last Post: 29-03-2014, 03:35 PM -
Wanted: Parker CD20 Stepper Drive
By drumsticksplinter in forum Classified Ads, Buy, Sell & SwapReplies: 0Last Post: 29-03-2014, 03:33 PM -
What voltage for stepper drive?
By Davek0974 in forum Plasma Table MachinesReplies: 1Last Post: 22-01-2014, 10:49 PM -
BOB & Stepper Drive
By GTJim in forum General ElectronicsReplies: 9Last Post: 22-08-2013, 07:17 PM
Bookmarks