Help Mach3

[Mikes Planes]

Hi Thank so much as always great help.
I have done all in last post and all is well but not sure on the lead so I have sent for a new one.
I would like to put my suds on a relay but I don't see where to connect it other the P16/P17. I have attached a copy of a relay board I have but don't see were VCClead go's on my BOB?? or if I use the one on the BOB were the power to the pump comes from??

Mike

[dazp1976]

Hi Thank so much as always great help.
I have done all in last post and all is well but not sure on the lead so I have sent for a new one.
I would like to put my suds on a relay but I don't see where to connect it other the P16/P17. I have attached a copy of a relay board I have but don't see were VCClead go's on my BOB?? or if I use the one on the BOB were the power to the pump comes from??

Mike

Your 5v VCC output on those 5axis type bobs is marked PC5V. your 5v GND is marked PCGND.
If using the on-board spindle relay, you cannot use P17 as an output. There is a jumper on the bob to switch P17 to either on-board relay use or Pin use.

I had:
P1= 0-10v Analog.
P2,3,4,5,6,7,8,9= 4 axis.
P10= estop:
P11,12,13,15= limit/probe.
P14= axis enable.
P16= suds coolant.
P17= spindle on/off.

That filled it.
Then needed more I/O so I upgraded to a UC300eth.