1st Build, Second machine

[m.marino]

Well folks we are on the home stretch and Jazz is doing great. The design has gone through some minor changes, but is pretty much on track for what was designed. Now the important part the pictures. Side note there are only 2 plates left to cut and 2 extensions to cut for the NEMA 23 shafts for the pulleys.



The HDPE you see the Z axis resting on is 15 mm thick and will be about what I am using for bed material. Right now discussing whether to mill in slots or just drill and tap it. The bed will be either HDPE around 200-250 grade or UHMWPE and looking at a couple of options on how to set that up. Need to get one more piece of energy chain for the x axis. I on the other hand am testing the BOB that I have done the work on to make the A axis work with the X and going to make sure that is all good and need to get the shielded wiring for the switches and most likely will need some more shielded 4 core for the motors as will need longer leads.

Also getting g-code ready for a couple of jigs and such as will be busy right from the get go once it is up here and bedded in. Again a very big thanks to Jazz for all his work, to James and Luke for the X axis supported round rails:tup: and for all the other folks that directly or indirectly aided in this project.


Michael

[Jonathan]

most likely will need some more shielded 4 core for the motors as will need longer leads.

I've got plenty of 4-core CY shielded if you need to buy some. Let me know how much you need - will be cheaper than elsewhere as I'm not trying to make money out of it!

[deannos]

I've got plenty of 4-core CY shielded if you need to buy some. Let me know how much you need - will be cheaper than elsewhere as I'm not trying to make money out of it!

I will vouch for that, it's a good price from Jonathan:tup: