operation cnc

[kingcreaky]

Morning All. Monday again :(

So, suppose I have the two peaces of 45x90 Ali Profile in my hand now.
I want to arrange them in the above formation.

Is there any product that enabled me to mount them together in this way (rather than a 90deg bracket at the back)

You would think there would be a fillet strip that runs in the 10mm extrusion that runs alongside the two peaces. Then obviously I could nut and bold aswell...

also, im keen to use 45x90 (only because thats what my design uses, and that was only because I was recommended to use KJN in leicester so I used a product from their range on the website. Now when I actually need to make an order. they neither answer the phone or email. So can anybody recommend a different supplier. Ive seen the sponsored link off here to 'metallin' however then dont do 45x90

so need answer too two questions

1.) How do I join to peaces of excursion together in the above formation?
2.) can anybody recommend a different supplier?

[asbo]

I was recommended to use KJN in leicester so I used a product from their range on the website. Now when I actually need to make an order. they neither answer the phone or email.

Why not just order it via their website? KJN - Suppliers or Aluminium Profile and Accessories