Thread: Upgrade? Chinese CNC Machine
Threaded View
-
02-04-2013 #11
Last Activity: 23-09-2017
Mach setup looks OK
Pics don't really show anything.
010.jpg is the best shot, I'm looking for dip switches that set microstepping. X and Y should be the same if the screws are the same and the motors are both direct drive.
On the picture of the circles, is the wide diameter X or Y ?
If it's X change the steps per on Y from 400 to 200
If it's Y then change X from 400 to 200 and run the file again.
Remember to click save settings, then OK and reboot.
Off to bed now, it's half past dark here, can you play quietly with yourself until morning ?Last edited by John S; 02-04-2013 at 12:43 AM.
John S -
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Yet another Chinese 3020 CNC upgrade thread!
By Pointy in forum Machine DiscussionReplies: 31Last Post: 18-02-2014, 01:04 PM -
A decent little (PCB miilling) Chinese machine...
By HankMcSpank in forum Machine DiscussionReplies: 5Last Post: 18-06-2013, 06:59 PM -
Chinese CNC machine modifications - Discussion
By craigrobbo in forum Milling Machines, Builds & ConversionsReplies: 2Last Post: 14-05-2012, 06:51 PM -
Electronics upgrade for an existing machine.
By Shinobiwan in forum Electronic Project BuildingReplies: 9Last Post: 18-03-2012, 04:01 PM -
Chinese CNC machine...whatchathink?
By HankMcSpank in forum Chinese MachinesReplies: 21Last Post: 11-04-2011, 05:21 PM
Bookmarks