Chinese 3040T Arrives

[Gregor]

hi
Does anyone have a Gcode I code use to make my first cut on this machine. I have tried to do my own design using Sketchup and then using Cambam but I seem to balls it up. (Still Learning)

[JAZZCNC]

hi
Does anyone have a Gcode I code use to make my first cut on this machine. I have tried to do my own design using Sketchup and then using Cambam but I seem to balls it up. (Still Learning)

Ok here you go a cut down version of the Aztec calendar I knocked up to test a machine, takes about 45-50mins depending on how machines setup.

You'll need 90deg V bit or Spot drill cutter that must go to a sharp point.
100mm square of material. To get the best detail from it use some thing hard has the material so it holds the detail better.

The X0 Y0 is the bottom left hand corner of the square. The code only cuts the Aztec engraving and doesn't cut out the square so you'll need to do this your self.

Should look like the picture when finished.