Rob's Build?

[Washout]

Ah I don't think Zapp do the kit I bought anymore and the closest to mine is the High Voltage 3 Axis one here: High Voltage Digital Driver Kit (Four axis)

The description has an error as this is actually the 3 Axis kit using DM856 drivers (mine was an earlier analogue version using AM752 drivers).

If you are going to cut wood only (I cut a lot of aluminium) then you maybe able to use the lower voltage kit - others will be able to advise.

As Jazz says though - the electronics is something further down the track - get the frame, gantry, ballscrews, rails, bearings etc. sorted out first.

[Jonathan]

If you are going to cut wood only (I cut a lot of aluminium) then you maybe able to use the lower voltage kit - others will be able to advise.

Higher voltage lets you go faster, so if anything it's the other way round since in general the feedrates for wood are higher than the feedrates for aluminium.

As Jazz says though - the electronics is something further down the track - get the frame, gantry, ballscrews, rails, bearings etc. sorted out first.

Agreed.