. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 08-04-2014 #18
    swisscheese's Avatar
    Lives in Melbourne, Australia.
    swisscheese
    Last Activity: 16-05-2014 Has been a member for 9-10 years. Has a total post count of 41. Received thanks 4 times, giving thanks to others 4 times.
    So the question is how do you make cambam output radiuses for curves instead of lots of straight lines? Ive been into the postprocessor and tried all options relating to curves, it outputed exact same code though.

    and no mach 3 for me!!!!
    Last edited by swisscheese; 08-04-2014 at 10:58 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Need to slow down a signal due to Safe Torque Off alarm
    By corkcnc in forum General Electronics
    Replies: 0
    Last Post: 04-06-2014, 11:35 PM
  2. how to smooth stl model, smooth curves out of straight lines
    By chris in forum DeskProto
    Replies: 4
    Last Post: 21-01-2014, 11:00 PM
  3. Help! Steppers losing steps and making a racket under slow feed..
    By fasteddy in forum Stepper & Servo Motors
    Replies: 23
    Last Post: 06-08-2011, 03:03 PM
  4. Forum Slow
    By pcstru in forum General Discussion
    Replies: 3
    Last Post: 27-01-2011, 03:54 PM
  5. stepper speed very slow
    By jonm in forum Stepper & Servo Motors
    Replies: 17
    Last Post: 02-11-2009, 12:39 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules