help with problem please

[martin54]

will try switching the axis around to see what happens, could probably use my bob to test the machine if I had to, I know that works fine lol

[JAZZCNC]

will try switching the axis around to see what happens, could probably use my bob to test the machine if I had to, I know that works fine lol

Would only do that as a last resort if it's not a spare BOB. Could be something else killing the BOB, if indeed it is the BOB, doubt somethings killing it it but could be.!
Something I would try that wont hurt is your parallel port cable.! . . . In past I've had cables give silly troubles but often they just don't work or are irratic never worked then stopped so it's a clutching straws move. But still easy try so worth doing for elimination purposes.

Another thing worth trying that won't hurt and is a big elimination is trying your PC. This takes the PP and software out the equation which are both candidates for trouble.!

[EddyCurrent]

Mine was doing that while messing about tuning the motors, I had the velocity and accel too high which was making them stall and trip out. The DRO was still going but the motors were not, to reset them involved power off/on cycle. They worked in jog due to lower settings.

[JAZZCNC]

Mine was doing that while messing about tuning the motors, I had the velocity and accel too high which was making them stall and trip out. The DRO was still going but the motors were not, to reset them involved power off/on cycle. They worked in jog due to lower settings.

Don't think this will be the same Eddy. Yours was caused by the wrong tuning stalling motors which tripped the stall detect built into drives which then needed power on/off cycle to reset the drives.! . . . . No such nicetys here I feel.

But it could be tripped motors from being tuned to close to edge and when machine gets hot after 10mins things tighten up and cause binding so worth knocking tuning back to see. .

Being 2 motors at same time makes think not thou.!!

[Clive S]

It might be worth blowing cold air over the driver chips to see if they are over heating and tripping out. ..Clive

[EddyCurrent]

Are the drivers compatible with the motors ?

[martin54]

Jazz, using my computer isn't really an option as it's built in to the machines old control box BUT I did use his computer to run my machine to eliminate the PP & the software, worked no problem at all. I also tried my serial cable on his machine to rule that out lol, Plus as the seller has now sent him 3 different bobs he has 3 cables of his own that we have tried as well.

Eddy, I've tuned the motors & backed them off far enough from their maximum that it shouldn't be a problem but the machine was doing it before I tuned the motors & the initial setting they give you to plug in to mach3 are so slow I can't see it being a factor. Compatibility I haven't got a clue about if I'm being honest but all 3 motors are the same & only 2 axis seem to have this problem. Jazz is right there are no safety cut outs with this stuff lol

Clive, it had crossed my mind that it might be down to heat in some way but wasn't sure what to do to try & eliminate anything like that, will try a couple of fans blowing on them.

Thanks for the help & suggestions people, gives me something else to try.