Need some help with a new SIEG SX2 Plus CNC Conversion

[Onocyclone]

New machine arrives tomorrow and I'll update the forum when I have shifted it out the crate :D

Just cleared all this shit out the garage :)

The machine is going on this solid oak table so it will not move an inch !!




The gray table is no more :) sledge hammer + crowbar = flat, ahahahahahaahhahahaha

[irving2008]

The machine is going on this solid oak table so it will not move an inch !!

You'll be surprised how much a supposedly solid table does move when a CNC'd table changes direction at speed!

[magicniner]

Tie your bench to the wall with a couple of heavy angle brackets, two hammer fixings in the wall, one for each bracket, should keep the table from jiggling too much,

- Nick

[irving2008]

What it needs is some diagonal x-bracing... and being tied to the wall...