Rotary broach tool holders and tooling

[dazza]

thanks mc
I did come across those a while back,they describe them as standard and for brass alu and mild steel.
id like one capable of holding its own with titanium and stainless so not sure on that one although it does say else where on the site regarding stainless..The best grade broach for broaching stainless steel of all types is PM M-4 broaches and changing feeds and speeds it can be done.
im surprised china haven't jumped on these holders.

[Dean jeffery]

thanks mc
I did come across those a while back,they describe them as standard and for brass alu and mild steel.
id like one capable of holding its own with titanium and stainless so not sure on that one although it does say else where on the site regarding stainless..The best grade broach for broaching stainless steel of all types is PM M-4 broaches and changing feeds and speeds it can be done.
im surprised china haven't jumped on these holders.

I looked at this way of broaching but limited by the amount of martial per side removal rate plus the 10% increase in pilot hole was no good for me, was also going to be titanium so would have made it impossible to get what I wanted.

Think max cut for my size was .63 per side I wanted 8mm flats and 12mm rads, double D or spur drive.

[m_c]

Just found the links to polygon's other website - http://www.buybroaches.com/ Lets you select broach material and coatings.

http://www.slatertools.com/rotary-broaches mentions that titanium is possible.