Boxford 160TCL to Mach3

[i2i]

you can get a good working machine for very little expense by using the existing drives, power supply and steppers. You can get this within the constraints of a single parallel port even with the atc if fitted. The existing power supply and drivers will run the steppers well, but if you need more performance, more powerful drivers and a larger power supply will be needed. What you need to decide is what you want from the 160 and even if you need greater performance.

[Jones_Rob]

you can get a good working machine for very little expense by using the existing drives, power supply and steppers. You can get this within the constraints of a single parallel port even with the atc if fitted. The existing power supply and drivers will run the steppers well, but if you need more performance, more powerful drivers and a larger power supply will be needed. What you need to decide is what you want from the 160 and even if you need greater performance.

I don't have any software, it was originally connected to a BBC computer, so are you saying that I can get this little machine working from a PC in its current state?

[magicniner]

The Mach3 license is very reasonably priced (especially with the current exchange rate) at $175, then as stated you can add a break out board (BOB) and PC running W98 with parallel port and you just have some wiring to do ;-)

- Nick

[i2i]

I don't have any software, it was originally connected to a BBC computer, so are you saying that I can get this little machine working from a PC in its current state?

not as it stands, to run mach3 on the 160 you'll need to interface the machine to a parallel port and configure mach3 to run the machine.

[novafeng]

Hi all

I have just aquired a boxford 160 and 190vmc and i am looking to convert them to mach3. i also have very little idea of how to go about it. i have been looking through the threads on here and i am getting an idea of what it entails but i am looking for some help

cheers

[Phill Spowart]

Morning,

I've also just bought a TCL160. Mine looks like a bog basic model, no tool changer turret or limit switches on axis. Everything it has works though, quite happily moves in jog etc.

Is it possible to get it running on a PC in completely stock condition? If I could do that and keep the use of the control panel I'd be very pleased. If not, are there any idiot level guides to putting new boards etc? I've seen Saracens thread, though it sounds like he's still experimenting and setting up. I've downloaded the free version of Mach 3 to have a look.