M_C,

I wasn't sure if I would be lucky enough to come across someone with experience, but I figured this would be a good start. From what I have seen the controller does work, and for right now it will do what I need it to do. I am going to look into a retrofit down the line, but that will have to wait until many other projects are finished. The tool changer is a one arm style as you mentioned. Any manuals, or advice that I can get is greatly appreciated. I have tried doing a search over on Practical Machinist, I found some answers, however it is the typical "not a HAAS, not a Bridgeport" nonsense as you mentioned.