. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Quote Originally Posted by Boyan Silyavski View Post
    BOB is supplied with 24v, relay board with 5v. I use different supplies for galvanic isolation of BOB, sensors,etc.
    Boyan Can you show just how you are connecting the relay to the board you might have to connect the -ve grounds to each other.
    ..Clive
    The more you know, The better you know, How little you know

  2. #2
    Quote Originally Posted by Clive S View Post
    Boyan Can you show just how you are connecting the relay to the board you might have to connect the -ve grounds to each other.
    He will definitely need to connect the two boards PSU 0V rails together, else all he'll have is two independent supplies with their respective 0Vs floating wrt one another. As mentioned in my last post, my relay board uses a FET/tranny on the input ...the switching/control voltage does not drive the relay coil direct. Therefore if your board is like mine, the notion that the "Pokeys57CNC does not output enough current on output 5v pins to switch a external relay" a misnomer (the input impedance of the relay board will likely be extremely high so will sink very little current at all)
    Last edited by HankMcSpank; 15-08-2015 at 02:57 PM.

  3. #3
    Guys, so i have BOB powered by separate 24VDC PSU and relay board powered by 5VDC PSU. Both grounds are connected/the earth, the body.

    So you say now i need to connect the together the 2 - /minus / pins of both the PSUs?

    Makes sense though i have never done that before on other boards and they worked
    project 1 , 2, Dust Shoe ...

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. CSMIO-IP/S Driving Relays directly
    By cropwell in forum CS-Lab (CSMIO)
    Replies: 10
    Last Post: 02-01-2017, 01:40 AM
  2. Using current as cutting force indicator?
    By mitchejc in forum General Electronics
    Replies: 10
    Last Post: 13-01-2015, 05:09 AM
  3. question about relays
    By frankman in forum General Electronics
    Replies: 3
    Last Post: 23-01-2012, 07:47 AM
  4. Current Set Resistors.
    By NzOldun in forum Motor Drivers & Controllers
    Replies: 1
    Last Post: 20-06-2011, 08:38 AM
  5. G540 Current set resistors
    By blueseidboy in forum Motor Drivers & Controllers
    Replies: 3
    Last Post: 23-08-2010, 02:21 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •