Greetings to all in MYCNCUK!

[JAZZCNC]

Not that it really matters, i'm not quite sure what "Orginal thread" JazzCNC is referring to, i'm pretty confident that the two discussions linked above, are infact the ONLY discussions to have taken place here on the forum regarding these machines, looking closely they don't appear to have been moderated, although posts have been edited by their original authors there is allot of pictures and information about these machines that should help you in your research.

Erm maybe it would matter if it was your Replys that went missing in the night.!!! . . . . . It's been 2yrs now so I'm fuzzy to everything that was written and went missing but I clearly 100% remember being attacked and accussed by Stoney because in post #7 I happen mentioned I build similair machine to Exel. So he assumed I was in business selling them and trying to discredit their machine to sell my own. When infact the truth was I only built them on request from forum members or very selectively approached those I thought could benefit and deserved help. This is mostly still true today but I do build more now than did before.!

But the point being I did reply and has can be imagined I probably didn't mince my words.!!! . . . . So where is that post because I certainly didn't remove it.? Stoney could Edit his own post but he couldn't remove or touch mine so who did.?
Truth of the matter is that thread today is fraction of what was actually said at the time.!! There were other posts on that thread that went missing or got trimmed to within an inch of there life of being unrecognisable to what I actually wrote.!! . . . . Just like has happened several times before on other threads with machine manufacturers.!!

I say what I say to help people and despite what some may think I don't do it because I get a kickout pulling a machine to pieces or to massage my huge ego.!! . . . My past record should show I don't comment unless I know what I'm saying is correct and can prove or I have experience. Yes in the past some folks have pushed my buttons and I've fired too quick. I still do just not so much.!!
But I think it's morally wrong to turn a blind eye and not point these things out to people who are wide open to buying machines that are wrong or over priced. Just like I think it's morally wrong to Sensor threads just to please the "one" at the potential expense of the "many".!!

Ok rant over said my piece.!