Giant 20' x 3' x 2' router build

[JAZZCNC]

I guess if I just use the m4 code it tell me if we wired it for it or not already?

Yes and it's likely not.! . . . But Charlie be aware that these spindles are not designed to be run in reverse.? They can unscrew the collet running in reverse if the forces are high.
In your case I think you'll be ok but still make sure you really tighten the collet.

[charlieuk]

Yes and it's likely not.! . . . But Charlie be aware that these spindles are not designed to be run in reverse.? They can unscrew the collet running in reverse if the forces are high.
In your case I think you'll be ok but still make sure you really tighten the collet.

ok great I havnt been out there today but will go investigate more tomorrow. I think I must have been running counter clockwise all this time then and not realy noticed it as the bits I have been using don't matter which direction they go.


although saying that I did try cut some wood once with a normal bit and it was a very average cut, maybe it had something to do with it spinning the rong way lol must give that another go now I guess and maybe it will actually cut ok haha

[Blackrat]

what happened to all the pics in this thread ?

have you cut any more boards ?

[longy]

what happened to all the pics in this thread ?

have you cut any more boards ?

I was wondering the same thing, even the pics from some of the build logs seem to be missing ? :(