Floating Head for 3020

[iBeta]

The word Impossible doesn't exist on this Forum.

This is simple thing to make. Just linear rails with spring pushing down for tension. The depth is controlled with the adjustable height plastic depth control.

Daft as it sounds you could just remove power from your Z axis stepper so there is no holding torque. Fit strong spring to pull down on Z axis then fit plastic collar to the tool to control depth.!! . . . .Instant depth control.

Thanks, yes, homemade may be the only way since I've a 57mm spindle - and there doesn't seem to be any floating heads for that diameter spindle. Not sure if just removing the power from the Z motor would be enough, the spindle is still attached to the thread.