Threaded View
-
02-11-2016 #11
That's very true Jazz but you and me are in it for different reasons.
The punter who doing his own machine and is prepared to take a chance doesn't have these expenses.
I have now got the go-ahead to do 15 machines down at Oxford in one lot. They are putting me up at the University dorms for 3 or 4 days, free grub and I shall leave them one spare unit which if one goes pear shaped they will swap over.
To be honest without these I would not have got the job as they don't want PC's and Monitors and the 990 series are too expensive for old training machines.
Good thing is it puts a load into use to soak test in one batch.John S -
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CSLAB CSMIO/IP-M 4-axis Ethernet Motion Controller
By dudz in forum CS-Lab (CSMIO)Replies: 35Last Post: 02-01-2017, 01:27 AM -
FOR SALE: Galil Motion Controller - PCI DMC 1842 - four axes
By lateAtNight in forum Items For SaleReplies: 1Last Post: 24-06-2014, 03:41 PM -
FOR SALE: Galil 1880 8 axis PCI motion controller
By Boyan Silyavski in forum Items For SaleReplies: 1Last Post: 03-06-2014, 07:39 PM -
Advice please! JAF Motion Controller issues!
By Mark Chard in forum Machine Control SoftwareReplies: 0Last Post: 31-01-2014, 05:03 PM -
eBay: Galil DMC-1580 Motion Controller 8-Axis
By Boyan Silyavski in forum Items On eBay UKReplies: 1Last Post: 25-12-2013, 10:30 AM
Bookmarks