DDSCV1.1 3 and 4 axis offline motion controller

[Merlin201314]

PS.
I remember someone saying that the 4 axis is not working/linking to the other axis..
well here is working, have a look

https://www.youtube.com/watch?v=8Pi-ramLLSo

Is a cheap controller, but it has a good potential if we find the way to crack the firmware and add some more features and routines

[JAZZCNC]

PS.
I remember someone saying that the 4 axis is not working/linking to the other axis..
well here is working, have a look

https://www.youtube.com/watch?v=8Pi-ramLLSo

Is a cheap controller, but it has a good potential if we find the way to crack the firmware and add some more features and routines

Maybe your miss understanding what was meant.? It was me who said doesn't work and I'm talking about Slaved axis. As in two motor/drives on separate outputs working as one axis.
That controller is exactly the same one I have and it DOESNT allow slaved motors. This video is just showing it working as 3 + 1 which the controller will do no problem. The fact they have twin screws means they are using dodgy practise of using one output to control two drives or even worse one drive to control two motors.?

IT DOESNT SLAVE TRUST ME.!!!!