Threaded View
-
11-12-2016 #12
Last Activity: 24-07-2022
Someone on the UCCNC forum directed me to a nice looking breakout board from Thailand, and I ended up ordering it to use with my UC300ETH.
It's designed to work with a Smoothstepper, and uses 3 ports.
There are not a lot of options in 24V breakout boards, and this looked like the best of the ones that I've seen, and also was the least expensive.
http://www.cncroom.com/break-out-boa...sg1gjepeu9ugh3
It shipped about 10 days ago. Hopefully I'll get it this week. I think it's out in the ocean somewhere right now.Gerry
______________________________________________
UCCNC 2022 Screenset
Mach3 2010 Screenset
JointCAM - CAM for Woodworking Joints
-
The Following 2 Users Say Thank You to Ger21 For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
anyone using an e-cut 1 mhz usb breakout board
By nobby in forum Control Hardware & SystemsReplies: 10Last Post: 22-10-2018, 11:50 PM -
Breakout Board
By Tomnewry in forum General ElectronicsReplies: 2Last Post: 12-12-2013, 07:24 PM -
eBay: Denford Novamill SmartStep Control Board + Spindle Board
By danielbriggs in forum Items On eBay UKReplies: 0Last Post: 30-05-2013, 06:52 AM -
eBay: UIM2901-5A Mach3 breakout board with spindle speed control
By Fivetide in forum Items On eBay UKReplies: 0Last Post: 05-02-2013, 07:25 PM -
Breakout Board
By croy in forum Electronic Project BuildingReplies: 10Last Post: 18-08-2011, 07:50 AM
Bookmarks