Help needed with Mach 3 - reset external flashing light

[Tom J]

Hi Dean

I follow your suggestion and got it light flashing before Reset is pressed.

I changed output pins. So far output 0 is taken by HV Enable, output 1 by spindle relay, and I did not want to change it, only added output 3 for 'Lamp Idle / Reset', so when 'Lamp run' spindle should start
Here is what I changed in pin configuration


In General Configuration Run Macro Pump is ticked.
in Output Signals Charge Pump signal is used with Port 10 and Pin Number 24, (Output 3, manual page 11)

Had to replace my blinking Led to standard one:)
I presume this macro is kind of light tower?

Light stays on after reset, which is kind of industrial standard for reset condition.
How to disable that light?
What have to be changed in script please?