3 Axis CNC router

[JoeHarris]

Thanks I think I'm clear, so did you just take three wires, one from each driver ALM+ and twist them together in one ferrule at pin 2 on the CSMIO?


Sent from my iPhone using Tapatalk

[Neale]

Thanks I think I'm clear, so did you just take three wires, one from each driver ALM+ and twist them together in one ferrule at pin 2 on the CSMIO?


Sent from my iPhone using Tapatalk

No, I took a wire from the first driver to the second, wire from second to third, etc, then to the CSMIO. Where two wires went to a single pin, I fitted them to one ferrule. Easy job.

[JoeHarris]

No, I took a wire from the first driver to the second, wire from second to third, etc, then to the CSMIO. Where two wires went to a single pin, I fitted them to one ferrule. Easy job.

Like this?

[Neale]

That looks about right.

[JoeHarris]

That looks about right.

Splendid! Thanks for your help. I'm going to try and find time to draw it out once more as a complete circuit to be sure before I start...

[JoeHarris]

That looks about right.

Here goes, I think this is my finalised estop and fault circuit: