Controls Cabinet size

[Neale]

I meant to reply but my original eBay order doesn't have the dimensions and I keep forgetting to measure it...

However, from memory, I think it's 500x400x200. In that, I have a CSMIO motion controller, four stepper drivers, safety relay, stepper PSU, psu relay. On the inside of the door I have a 24V and a 5+12V PSU. Two 12V fans on one side blowing air in, across the stepper driver heatsink. It fits, but there isn't really any space spare and wiring is more difficult if space is tight. If I were doing it again, I would go a little bigger. Beat easy, if you have the bits, is to lay them out on the bench and see how much space they take up, allowing for things like internal cable guides.

Don't know if that helps as it all depends on exactly what you are going to be installing.

[driftspin]

I meant to reply but my original eBay order doesn't have the dimensions and I keep forgetting to measure it...

However, from memory, I think it's 500x400x200. In that, I have a CSMIO motion controller, four stepper drivers, safety relay, stepper PSU, psu relay. On the inside of the door I have a 24V and a 5+12V PSU. Two 12V fans on one side blowing air in, across the stepper driver heatsink. It fits, but there isn't really any space spare and wiring is more difficult if space is tight. If I were doing it again, I would go a little bigger. Beat easy, if you have the bits, is to lay them out on the bench and see how much space they take up, allowing for things like internal cable guides.

Don't know if that helps as it all depends on exactly what you are going to be installing.

Good tip to get al the bits and make a layout.

But at least 500x400.

Ok...

Thanks guys.



Verstuurd vanaf mijn SM-A320FL met Tapatalk