That would be great cheers :)
So far I have..
4 drivers https://www.omc-stepperonline.com/st...or-dm860t.html
Breakout board https://www.omc-stepperonline.com/st...kit-st-v2.html
UC300 eth - 5lpt http://cncdrive.com/UC300.html
24v PSU
5v PSU
toroidal psu with no bridge rectifier or caps as driver accept AC
stop/start button (1no 1nc) NVR
emergency stop button
2.2kw water cooled spindle with VFD
water pump for spindle
big enclosure

Still to buy - control cable?
limit/home switches- do you have them at each end or just for home position?