Aluminium Extrusion Router Build

[fgfreek32]

Hello Freyer

i am new here and i saw your design and my question is about the x axle moving by two ball bearing and one motor joined together.
does this work ?


grt Frank

[NFryer]

Hello Freyer

i am new here and i saw your design and my question is about the x axle moving by two ball bearing and one motor joined together.
does this work ?


grt Frank

Hi Frank, you can use a single motor and a long belt to connect the two x axis ballscrews together, check out the build log of Joe Harris, he did it that way. I decided on using two separate motors to drive the x axis ballscrews. Either way works.


Sent from my iPhone using Tapatalk

[fgfreek32]

thanks for the reply,will look at the log

grt frank