Tapping Delrin for M10 threaded rod - doable?

[HankMcSpank]

Thanks for your comments...you make a good point about using delrin block vs rod.

Where's the best place to source Delrin block? (I can only find Delrin rod on Ebay)

[Lee Roberts]

Thanks for your comments...you make a good point about using delrin block vs rod.

Where's the best place to source Delrin block? (I can only find Delrin rod on Ebay)

How much do you want, i have got a fair bit laying around i could send you. Mostly already cut up into blocks like the pic in the link below ready to be drilled/tapped.

The size of the blocks more then recive an M8 tap with no problems, i dont think you would have any problems using them for an M10 tap i will have a look in a mo for you!

Please see this link: http://cgi.ebay.co.uk/ws/eBayISAPI.d...m=250235119898

Lee