Threaded View
-
22-02-2021 #19
Last Activity: 27-04-2025
John,
If that DIYCNC board is the one with the dodgy PSU (private conversation) - that has a charge-pump circuit on it which, if enabled, will inhibit the outputs until it detects the charge-pump signal (just a toggling signal) from linuxCNC. That might be an easy win for you.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Problem using cnc3018 with offline controller
By gikkalan in forum Chinese MachinesReplies: 4Last Post: 11-07-2021, 05:33 AM -
Very Sick Lenze 534 Controller
By Ricardoco in forum Motor Drivers & ControllersReplies: 32Last Post: 09-09-2020, 11:19 PM -
Boxford 260VMC with toolchanger Lenze spindle speed issue/query
By swood1 in forum Boxford Vertical MillsReplies: 0Last Post: 27-03-2018, 03:18 PM -
tb6560 controller problem
By Wayne B in forum Linear & Rotary MotionReplies: 3Last Post: 22-01-2018, 10:58 PM
Bookmarks